I’ve discovered that one of my biggest pain points with historical costumes is trying to have my pins handy while I’m pinning on 12 yards of trim. I try to have my magnetic pin cushion near me while I’m working, usually resting on the edge of the couch, but then Bobo will come along and knock it off. (Yes, gravity still works Bobo… thanks for checking!)
I was joking to D that I needed to hang my magnetic pin cushion on my dressform somehow to make my life easier and her response was something along the lines of, “Well why don’t you?”
So today’s post is possibly useful to no one but me, but now I’m excited to try out my new dressform magnetic pin cushion on my next outfit!
I purchased some super strong magnets from Home Depot. (I love Home Depot in case it’s not obvious…)
I measured my dressform neck circumference and added 3″ for how long to make my pin cushion strap. My dressform neck is 13″, so I cut a strip 16″ long and 3.5″ wide out of some leftover quilting fabric.
I folded the strip in half lengthwise and made a tube by sewing along the length of the strip using a 1/4″ seam allowance. Then I flipped the tube inside out and ironed it flat.
I folded the strip in half to find the center and marked a line 2 3/4″ from the center.
I stitched along the line, dropped the magnet into the tube, and then marked a vertical line on the other side of the magnet. I sewed along the new line, sealing the magnet in.
I closed the ends by folding the raw edges inside and stitching the tube closed on both sides.
I took my magnet necklace to my dressform and pinned it on and marked where the ends overlapped. I used a pin to mark where the overlap is, but you can also use chalk or a fabric pen.
Then I took the magnetic necklace off the dummy to sew a closure on. I prefer hooks and snaps over velcro because velcro can tear up fragile materials that I might be draping, but whatever you have on hand will work. I went with a huge snap because I have a ton of these.
And here is the finished magnet pin cushion necklace!